Item Type: Magnetic Spring Steel Plate PlatformMaterial: PEI, Spring Steel, Soft MagnetSize: Approx. 300 x 300mm / 12 x 12inUse: Good 3D Printer Accessory ToolPEI Spraying Thickness: Approx. 0.25mm / 0.01inPEI Film Thickness: Approx. 0.25mm / 0.01inSpring Steel Plate Thickness: Approx. 0.4mm / 0.02inMagnetic Rubber Plate Thickness: Approx. 1.2mm / 0.05inOverall Thickness: Approx. 2.1mm / 0.08inPackage List1 x Spring Steel Build Platform1 x Magnetic Rubber PlateYou do not need to worry about the printout curling at 60C bed temperature. It will also print PETG well, but the temperature of the hotbed needs to be around 8085.1[Suitable Models] The 3D printing spring steel bed plate is applicable for Anet E12 E16 A8Plus ET5 series and for Voron and for Artillery SW X1. And can do the perfectly fitting. 2[Simple Operating] Very easy to use, just paste a the platform magnetic baseplate onto a heated bed, then place a steel platform with a PEI surface on top. The maximum temperature of the printing bed plate is 130. 3[2 Parts] The PEI plate consists of two parts, a flexible steel platform coated with a textured PEI surface on one side and a magnetic baseplate with adhesive on the back. 4[Print Directly] Excellent adhesion is achieved when the temperature of the heated bed is about 60C. You can print directly on the PEI plate. 5[Gently Bending for Removing] When the temperature of the heated bed reaches room temperature, the printout easily falls off the surface. If the print is still stuck, gently bending the plate will help remove it.