for FPV DIY Parts<br> Colour:Black<br> Material:PC<br> Usage Notes for tlne mitter Diversity Board:<br> TX1 and TX2 must cperate on frequencybands that are not integer multiples of each otter.<br> The remote control.should be configuredto external TX mode.<br> Set the CRSF seriaI port baud rate to 921K on the remote.control.<br> Both mitters should have the same telemetry rate, preferably set to 1:64<br> Each mitter must have a packet rate not exceeding 250Hz<br> The power input rarge for the mitte.r diversity board is 6--5V<br> (ensure compatibilit with the mitters supported voltage range, 2-3S batteriesare recommended).<br> Usage Notes fo. the Receiver Diversity Board:<br> Ensure RX1 successfully pairs with TX1,<br> and RX2 successfully pairs with TX2.<br> Alternatively, elnsure RX1 successfully pairs witlh Tx2,<br> and RX2 successfully pairs with TX.<br> Due to different product batches, the appearance may vary, which does not affect the use<br> Type: A<br> Package Contents:<br> 1x Receiver Board<br> Only the above package content, other products are not included.<br> Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.