【Oil Pumping】: This electric oil extractor pump can help to efficiently and practically exchange car engine oil. And it can not only pump oil, but also pump hydraulic oil and other liquids. 【Multiple Application】: This electric oil extractor pump is widely used in medical equipment, chemical equipment, shipbuilding, beverage, carpet and floor cleaning, water purification and treatment equipment, vehicle cleaning, agricultural spraying, etc. 【Battery Clamp】: This electric oil extractor pump works by connecting the clamps to the 12V car battery and is widely used in general industrial equipment. And with the simple on/off switch, it allows you to easily operate it as an ideal equipment for quick and clean oil changes. 【Simple Operation】: This electric oil extractor pump is easy to use, and after the oil pump, you can remove the hose and let the pump work for a while, carefully pump the remaining oil into the pump or pump water for a while until pump head is clean. Specifications: Rated voltage: 12 V DC. Rated power: 60 W. Maximum pressure: 0.8 MPA. Maximum flow rate: 6 l/min. Pump diameter: approx. 4.8 cm. Length: approx. 14.5 cm. Hose size drain (diameter x length): approximately 11 mm x 140 cm. Inlet pipe diameter: approximately 8 mm and 6 mm. Inlet pipe length: approximately 100 cm. Cable length: approximately 30 cm. Clip length: approximately 8 cm. Main color: black <p >Instructions for use: 1. Let the car engine run for a while. When the oil temperature changes to about 50 degrees, start pumping the oil. 2. Plug the pump into the power supply, let the pump run for a while, and check whether the input and output are normal. 3. Open the fill cap, remove the dipstick and push the pipe into the bottom of the connection until the pipe does not move. Then insert the oil dipstick inlet tube towards the end (the tube in the bottom of the tank, the concave bottom to fully pump the oil). As no oil is swollen very slowly or discontinuously, this is usually caused by loose pipes and castings. You need to reinstall the tubes and molds). Note: 1. Please allow 1-3mm error due to manual measurement. Thank you for your understanding. 2. If you want to connect this pump to AC power, you will need an inverter. 3. Please use it when the engine is hot, the engine oil is hot and the viscosity is lower. This is easier and faster. Shipping quantity: 1 piece