The 3D print style use PLA Material<br> We can also customize more style, please contact us if you need.<br> A 3D printed F1 style steering wheel for your Logitech G setup.<br> Aembly required.<br> Disclaimer:<br> Requires disaembly of your Logitech unit.<br> 1. Remove six small Phillips head screws in back of steering wheel controller.<br> 2. Remove six large hex screws from center of steering wheel.<br> 3. Steering wheel is now free. Carefully separate a few inches, then unplug main board. You may now remove the steering wheel.<br> 4. Remove screws fastening L2, L3, R2, and R3 buttons. Set these buttons aside, you will not need them.<br> 5. Remove screws securing main board, then remove main board and set aside.<br> 6. Remove remaining trim from original steering wheel.<br> 7. Re-install main board onto this trim.<br> 8. Plug in and re-install main board with trim to main steering wheel unit.<br> 9. Install F1 Racing Wheel (+ buttons) over top of main board using the six large hex head screws and you are done!<br> Please install at your own risk. We are not responsible for any damages caused by improper use or installation.<br> All prints are made to order with sustainable, plant-based plastic that is non-toxic and 100% biodegradable.<br> Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-DIMEANI official store