110 micron filter cartridge, efficiently removes small particles and separates water from your fuel. 2Separates water from fuel, prevent water from rusting and abrading oil supply systems. 3Can reduce the frictional resistance between the relatively moving parts in the engine and reduce the wear of the parts. 4Easy to install and replace filter cartridge when required, convenient to use. 5Fuel filter water separator, outboard engine parts, fits for Yamaha, for Honda speedboats motorboats, etc. Conditon: 100% Brand New Item Type: Marine Fuel Filter Water Separator Material: Metal + Nylon Model: S3213 Color: As Pictures Shown Application: Outboard engine parts, fits for Yamaha, for Honda speedboats motorboats, etc. Length: Approx. 267mm/10.5in Width: Approx. 102mm/4.0in Height: Approx. 102mm/4.0in To Drain Water: 1. Loosen self-venting drain plug to drain water from bowl into a container. 2. Tighten drain. 3. Use primer bulb to fill filter with fuel. 4. Start engine and check insure there are no leaks. To Replace : 1. Loosen self-venting drain plug and drain the into a container. 2. Remove filters from mounting bracket with bowl connected. 3. Remove bowl from filters and clean o-ring gland on bowl. BOWL IS REUSABLE * DO NOT DISCARD. 4. Lubricate o-ring with oil or grease and install on bowl. 5. Install bowl onto new, tighten by hand. 6. Lubricate filter top seal with oil or grease. 7. Fill filter/bowl assemble with clean fuel and attach onto mounting bracket, tighten by hand. 8. Start engine and check to insure there are no leaks. } 1 xFuel Filter Water Separator Assembly 2 xConnector 2 x Gasket 1.Draining of water or replacement of is determined by contamination level of fuel.2.Inspect the collection bowl for water daily and service as necessary.3.Replace s at least once a year or when a decrease of power is noticed.