2 SETUP OPTIONS WITH INCLUDED PARTS; Incredibly simple, damage-free setup with 3M Command Adhesive strips rated to hold up to 5 lbs each, or setup with included screws and anchors for scenarios where a more heavy duty setup is required. WIDE RANGE OF COMPATIBILITY: Uses 2 separate brackets that you can set at whatever distance required for your device, allowing for wide compatibility. The brackets will fit any device 13mm thick or less, although some thicker devices/cases may also fit if they have tapered edges. In many cases, can be used with protective cases left on (if total thickness is under 13mm). ACCESSIBLE PORTS: The Koala Mount 2.0 was specifically designed to leave as much space open as possible on the sides and bottom of the device so that most ports will still be accessible, depending on your device. For example, even with an iPhone 6 mounted in portrait mode, the headphone jack is still accessible. BUILT-IN CORD CLIPS: There are 2 different styles of cord clips integrated into each bracket. The side clip is a temporary clip that is super easy to use and is meant for holding your cord while the mount is not in use. The bottom clip is a semi-permanent clip designed to hold your cord at all times. MAKE IT PERMANENT: If you are looking for a secure, permanent mount from which a device cannot be removed, you can use 2 sets of Koala Mount 2.0 brackets to lock in a device by attaching the 2nd set of brackets with Command strips.