Feature:1. Smart Control: This solar charge controller enables light control, time control, business control, and so on, very reliable. 2. Safe Charging: Comes with 3-stage PWM adjustment charging mode for strong charging, balanced charging, and floating charging. 3. Higher Security: Also has overcharge protection, over discharge protection, over current protection, short circuit protection and reverse connection protection. 4. Good Matching: Ideal for 6V and 12V battery systems, the battery regulator has household type and street light type design. 5. Easy to Install: Designed to have a light weight and a compact size as well, the installation is very convenient to complete. Specification:Item Type: Solar Charge Controller Model: JC0603 Material: ABS Application: For solar charging and discharging control. Rated Voltage: 6V or 12V. Strong Charging Voltage: 7.4V or 14.8V. Balance Charging Voltage: 7.25V or 14.5V. Floating Voltage: 6.85V or 13.7V. Under Voltage Protection: 5.4V or 10.8V. Brownout Recovery: 6.5V or 13V. No Load Power Consumption: 6mA Voltage Drop in Charging Circuit: 0.2V Voltage Drop in Discharging Circuit: 0.1V Maximum Charging Current: 3A Maximum Load Current: 3A Regulator Protection: Overload protection, reverse connection protection, over discharge protection, overcharge protection, short circuit protection, etc. Charging Method: PWM Regulation Method Rain Control: Wait until the rainwater in the sink is soaked in the rain control line. Use Height: 5500m, over 2000m needs to reduce power consumption. Working Temperature: -20~55 LEDSTATUSFUNCTION CHARGINGOFFAt night or the battery is not connected. ALWAYSONBattery in equalization charging status. POWERCURRENT GREEN LIGHT ONRegulator normal output. GREEN LIGHT OFFRegulator output protection. How to use: 1. Installation environment: Install in a dry and ventilated place. 2. Wiring method: A. Battery, positive pole is on the left, and make sure the connection is correct. B. Then connect the battery board, positive pole is on the left, the connection is correct, the charging indicator light is on, and it enters the charging state. Otherwise, check the wiring. C. Connect the light source again, the bulb and the positive pole are on the left, the connection is correct, the bulb is on. In addition, the street light type light is long off during the day, and the undervoltage and overvoltage are off for a long time. Otherwise, check the wiring. D. Finally, connect the rain control line, connect the rain control line to the sink above the lamp, and check whether it is reliable. The rain control line should not be too long, no more than 1 meter. Too long will affect the sensitivity of the rain control. The shorter it is, the more sensitive it is. Note: The above steps must be connected in order, otherwise the regulator will be damaged. 3. The regulator contains a DIP switch, 8421 codes timing, so the user needs to open the shell to operate regularly. After opening the shell, you can see the DIP switch. The specific operations are as follows: The DIP switches, 1234 correspond to the timed time, 8421, respectively: A. If the user needs to set the timing for 6 hours, just turn up the corresponding dials of 2 and 3 to set the LED light to light up for 6 hours at night. For example, if the timing is 11 hours, just turn up the corresponding dial codes for 8, 2, and 1. You can set the LED light to light up for 11 hours at night. B. If the user turns up all the dial codes, 8421, the regulator will default to full light controlC. If the user turns down all the dial codes, 8421, the regulator will default to the user system and the load has 24H output. .Package List:1 x Solar Charge Controller