Brushless Electronic Speed Controller 70A 2670 2-6S LIPO Compatible with Multi-axis UAVs

Adopting 32-bit high performance processor STM32G071, the working frequency is up to 64MHz, and it supports up to 128KHz motor PWM frequency. PCB adopts 8 layers of 3OZ immersion gold process, high power MOS combined with metal heat sink, high current load can also be effective heat dissipation, continuous and stable work. Support motor unidirectional, bidirectional, with brake and other motion modes. Support low voltage protection, temperature protection, blocking protection, current protection and other multiple protection. The ESC automatically detects the throttle signal when it is powered on, supports all signals, and at the same time supports signal protocols such as PWM, Oneshot and Multishot. Widely used in multi-axis drones, fixed-wing aeromodels, model boats, climbing cars, model cars and other scenarios. Model Name : SQESC 2670 Processor : STM32G071 Input Voltage : DC 7V-25.2V (2-6S Lipo) Continuous current (good heat dissipation) : 70A Maximum current (good heat dissipation): 110A Supported firmware : BLHeli_32 BLHeli_32 Firmware: SEQURE_G071_01 AM32 Firmware: SEQURE_G071 Signal protocol: (all), PWM, Oneshot, Multishot, etc. Programming: Support Throttle Calibration : Support Angle Setting : Support Current Detection : Support Telemetry Signal: Support Motor Steering Setting :Support RGB LED color light : Support Application Scenario: Multi-axis drone, fixed-wing aerial model, model boat, climbing car, model car, etc. Depending on the batch, the appearance and color of the product , but this does not affect use. Colour:Photo Color Material:plastic+metal Package Contents: 1 x Motherboard 1 x 14awg 100mm black silicone wire 1 x 14awg 100mm red silicone wire 1 x 35V 680UF high frequency capacitor 2 x 18 specifications heat shrinkable tube 50mm 2 x 18 gauge heat shrink tube 28mm Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.