Original LCD Screen and Digitizer Full Assembly for Fitbit Versa 2 Before Installation Notes Tips 1: Test before installation When testing, do not remove any protective film or tags. Please pay attention to the problem of static electricity. Before attempting any repair, be sure to ground yourself with an ESD (electrostatic discharge) strap. This will prevent static electricity from damaging the electronic components within the watch. Ensure you wear eye protection and use caution not to cut your finger with glass splinters. Tips 2: Simulate testing Screen replacement is a very fragile product. We strongly suggest testing before installation. Please simulate testing by separating the watch, connecting the motherboard, LCD or screen, audio cable, and new replacement, then power on to test. If the test is successful, proceed with installation. If there is no display, immediately. Do not force installation. We will not be responsible once the screen is installed. Tips 3: Do not over-bend cable Please make sure the LCD cable is not over-bent. Bending beyond 90 degrees may cause a black display. About the product 1. Replacement LCD Screen and Touch Screen Digitizer Assembly for Fitbit Versa 2 2. Replace your broken or unusable part with a new one 3. Restore your device to like-new condition 4. Fully compatible and functional 5. Each item is tested and in good condition before shipping 6. Professional installation is highly recommended. We will not be responsible after the screen is installed