LCR-TC1 1.8" TFT LCD Display Multi-meter Transistor Tester Diode Triode Capacitor Resistor Test Meter ESR LCR NPN PNP MOSFET COD LCR-TC1 Described as follows Feature: For detecting NPN and PNP transistor, capacitor, resistor, diode, triode, N-channel and P-channel MOSFET, IGBT, JFET, triac and battery, resistor and capacitor and other components, etc. Put the pins of component in corresponding area, then dial the little handle and the detector will test it automatically, finally the results will display on the back light TFT screen clearly. ( Use 12864 liquid crystal display with green backlight). After detection, align the infrared remote control with the "IR" light, then pre the button in the remote control, if the detector succefully decode it, it will display the data code and infrared wave form. Measurement results represent by TFT graphic display(160x128). Support Chinese and English. One key operation, Auto Power Off(Timeout Settable). Can also pre the multi-functional button to close the detector. Specification: Color: White Size: 70*90*28mm/ 2.71x3.58x1.10 inch Display: 1.8 inch TFT Screen, Color Screen Diode Range: le than 4.5V Transistor Detect Area: 0.01-4.5V Zener Diode Detect Area: 0.01-30V Triac Range: IGT le than 6mA Capacitance: 25pF-100mF(Please discharge capacitor before testing) Resistor: 0.01-50M Inductance: 0.01mH-20H Power Voltage: 3.7V Power: Built-in Rechargeable Lithium Battery Package Included: 1 * Multi-functional TFT Transistor Tester 1 * Electronic Component Set 1 * Micro USB Cable 3 * Test Hook Operating Instructions Key operational definitions Multi-function key has two actions: Short pre: Pre the key and not le than 10 ms, release key within 1.5 seconds Long pre: Pre the key more than 1.5 seconds Power on In the power off state, short pre the multifunction key, the tester is turned on and automatically measured. Power on &measurement interface Detect transistor In the power off state or the test is completed, put the test element into the transistor test area of test seat, and pre the locking handle, short pre the multifunction key, the tester automatically measure, graphical display of measurement results when testing is complete. Warning: Always be sure to DISCHARGE capacitors before connecting them to the tester! The tester may be damaged before you have switched it on! Warning: We do not recommend using the tester to measure the battery! The battery voltage must be le than 4.5V, otherwise the tester may be damaged! Component placement Test seat are divided into transistors and zener diode test area, detailed in 1.1 Description. No, unknown, or damaged part TCR-T7 Described as follows 160x128 TFT display Multi function key Transistor test area Zener Diode test area IR receiver window Micro USB Charging Interface Charge indicator LED Features: TC-V2.12k is a TFT graphic display Multifunction Tester. Transistor Tester Automatic detection of zener diode0.01-30V Self test with automatic calibration IR decoder Support Hitachi IR coding IR waveform display Infrared receiving instruction Other: Measurement results using TFT graphic display(160x128) One key operation Auto Power Off(Timeout Settable) Built-in high capacity rechargeable Li-ion Battery Li-ion Battery voltage detection Support Chinese and English Warning: Built-in Li-ion Battery, it is strictly prohibited the tester immersed in water, or near a heat source! Warning: For your personal safety, please strictly comply with the use of Li-ion Battery specifications and precautions!