The CAN FD to RS232/RS485 converter is a DIN-rail-mounted bidirectional converter between CAN FD and RS232/RS485. It offers high speed, low latency, stable performance, ease of use, and excellent cost-effectiveness It supports five data conversion modes: transparent, transparent with ID, standard protocol, Modbus, and custom header and trailer. It enables interconnection between CAN and serial devices and is compatible with CAN FD and CAN 2.0A/2.0B protocols The device supports PC software configuration, comes with a built-in 1202 bus resistor (DIP switch for quick access), supports DIN rail installation, and is easy to configure and efficient to install 3 filtering methods, 32 hardware filters It can be set to receive only extended frames, only standard frames, or custom frame . It can be set to receive up to 32 groups of CAN to avoid interference from large amounts of data Working voltage:DC 9V-36V, 12V 1A recommended Installation method:Guide rail installation Reload button:Guide rail installation indicator light:POWER, WORK,COM CAN CAN port specifications:1 CAN port, supports CANFD, compatible with CAN 2.0A/2.0B CAN port baud rate:Arbitration domain baud rate: 5Kbps - 1Mbps;Data domain baud rate: 100Kbps - 5Mbps Terminating resistor:Built-in 2 1200 terminal resistors,Turn any one of the DIP switches to ON and connect a 1200 resistor in parallel. Turn both switches to ON and connect two 1200 resistors in parallel Serial port specifications:Support one RS485 or RS232 access conversion mode:Transparent conversion, transparent conversion with ID, standard conversion, Modbus conversion and custom frame header and frame footer conversion Color:As Shown Material:plastic Package Contents: 1 * CAN FD protocol converter Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.