Auto detection of K-Line/CAN, with option to bypass and force preferred communication protocol. Temporary bypass of immobilizer to allow bench flashing on ME7. Boot mode support for ECUs with C167 and ST10 processors. EEPROM read/write functions for select ECUs included. TPROT level checking for MEDC17 without opening the ECU. Installation instructions: 1. Install on Windows 7 system. 2. Properly install driver before opening software; software will not launch otherwise. Use driver from included CD—do not use drivers from other MPPS versions. This module enables advanced functions for a range of ECUs including M3.8, M3.9, ME7xx, MED9, MED17, EDC15/16/17, Delco, Trionic, and others. Compatibility: - 6JF: Full Read/Write and EEPROM via K-line - 8DF: Full Read/Write and EEPROM via K-line - 8F2: Full Read/Write and EEPROM via K-line and CAN - 8F3: Full Read/Write and EEPROM via K-line and CAN - 8GM: Full Read/Write and EEPROM via CAN - 8GS: Full Read/Write and EEPROM via CAN - 5SF3: Full Read/Write Flash and EEPROM via CAN - 5SF3: Full Read/Write EEPROM via K-line - 5SF8: Full Read/Write Flash and EEPROM via K-line and CAN - 5SF9: Full Read/Write Flash and EEPROM via CAN Material: ABS plastic Color: Black Package Contents: 1 x MPPS V18.12.3.8 1 x Breakout Tricore Cable 1 x Connection Cable 1 x CD Note: Light reflection and display differences may cause slight color variation between image and actual item. Measurement error allowance: +/- 1-3 cm.