Latest ELM327 version for improved Ford compatibility Manufactured with a switch to connect to different CAN buses Designed for use with FORScan software Compatible with FORScan, Elmconfig (supports baud rate 34800 only—verify before ordering), FF2, and FoCCCus Basic features: Reset fault codes, trouble codes, and parameter IDs (PIDs); modify vehicle configuration data; run tests and service procedures Supports MS CAN bus and HS CAN bus ELM327 USB 25k80 with switch for Ford diagnostic cable Product Introduction: One ELM327 OBDII USB diagnostic cable with switch. Designed for Ford and Mazda vehicles. When used with compatible software, it enables detection of modules not visible to standard OBD2 scanners. This includes reading trouble codes, PIDs, running tests, and performing service procedures unavailable on standard OBD2 scanners or stock ELM327 devices. Pin Configurations: Switch in “outside” position: HS CAN — uses pins 6 and 14 Switch in “inside” position: MS CAN — uses pins 3 and 11 Supported Software: FORScan Elmconfig (supports baud rate 34800 only—verify before ordering) FoCCCus Note: Many Ford and Mazda models (from approximately 2003–2004 onward) feature both HS CAN and MS CAN buses. While HS CAN complies with standard OBD2 specifications and uses pins 6 and 14, MS CAN is manufacturer-specific and uses non-OBD2 pins (3 and 11). This ELM327 has been modified to support MS CAN communication. Color: As shown Material: ABS Package Contents: 1 × Diagnostic scan tool