Specifications:Applications: widely used in general industrial equipment, medical equipment, chemical equipment, vehicles, cleaning, agricultural spraying, pipeline pressure, air purification, coal and metallurgical industry, shipbuilding, beverages, water purification and water purification equipment Rated voltage: DC 12VRated power: 60WMaximum pressure: maximum flow 0.8MPamaximum flow: 5L/minpump diameter: about 4.8cm, length: about. 14.5cmOuter pipe size: approx 10mm x 137cm (diameter * length)Inlet pipe diameter: about 8mm, 6mm, length: about 110cmLabel length: about. 68cmCutting length: about 8cm black colorHow to use:1) Start the car engine and run it for a period of time. When the oil temperature becomes about 50 degrees, start pumping2) Then connect the pump to the power supply, run for a while and observe whether the air inlet and socket are common3) Then open the filler cap, take out the pepper stick, and force the pipe into the bottom of the joint until the pipe does not movePut the water inlet pipe into the end from the oil dipstick screen (put the pipe into the bottom of the oil tank, the bottom depression, and pump the oil completely); Since there is no oil or the pump pumps out very slowly or intermittently, it is usually caused by loose pipes and fittings.4) After pumping, remove the pipe, and then run the pump for a period of time to clean the remaining oil pump or pump water for a period of time until the pump head becomes clean5) If it is not used for a long time, it cannot suck. Then simply pour water into the pump and run the pump for several minutes until the air is completely dischargedPackage contains:1st x oil pump1 x 10mm outlet pipe1st x 8mm hose1st x 6mm hose Note:If this pump is to be connected to an AC power supply, a power converter is requiredDue to manual measurement, a deviation of 1-5 mm is allowedThe color of the object may be slightly different from the image due to differences in light and screen