PIC Programmer PICKit 3 Universal Compatible with ICD2 and PICKit 2

PICKIT3 Programmer USB 12 Mbits per second interface to host PC. Real-time execution. compatible with MPLAB IDE. free copy included. The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers using the powerful graphical user interface of the MPLAB Integrated Development Environment IDE. The MPLAB PICkit 3 is connected to the design's PC using a USB interface and can be connected to the target via an debug RJ-11 connector. compatible with MPLAB 2, MPLAB 3 and MPLAB REAL ICE. Supports low voltage to 2.0 volts, 2.0v to 6.0v range. Diagnostic LEDs for power, busy, error. Read and write program and data memory of microcontroller. Erase of program memory space with verification. Freeze-peripherals at breakpoint. Program up to 512K flash with the Programmer-to-Go. Instructions for use: Installing the microcontroller, 28-pin and 40-pin microcontroller left aligned with 28/40P A flag line, short-circuit cap on the A position. The 8,14,18,20-pin microcontroller aligned on the left with 8P/14P/18P/20P flag line B, shorting cap on the B position. The ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming operation. Note: a separate program seat can not program the chip, programming functions are supported when using the specified connection. The seat supports the following programming microcontroller: compatible with PIC16/18XX 40PIN Series devices, except 16F59. compatible with PIC16/18XX 28PIN Series devices, except 16F57. compatible with PIC16/18XX 18PIN Series devices. compatible with PIC 8PIN/14PIN/20PIN family of devices, except 10FXX. Colour:Red. Material:plastic. Size:14.5 x 7 x 4CM. Package Contents: 1 * PICKIT3 Simulator 1 * USB Cable 1 * 6Pin cable 1 * Universal Programmer Seat