1. Synchronizes the output of the servo system and servo control output signals for precise control of servo performance. 2. Tests changes between different servos. (1 millisecond = 1000 microseconds) Operating Voltage: 4.8-6.0V Dimensions: 75x38x15mm Weight: 26.2g Signal Width: 800-2200µs 1. 50H analog servo signal cycle, 20µs, frequency, 50Hz 2. 125H digital servo signal cycle, 8µs, frequency, 125Hz 3. 250H digital servo signal cycle, 4µs, frequency, 250Hz Instructions: Automatically enters manual mode upon power-up. Turn the potentiometer to increase or decrease the signal width. select again to select between center and automatic modes. PW to select a pulse width between 125H and 250H. Warning: Digital or analog signals should be adjusted using the corresponding servo system settings before plugging into the steering servo to avoid damaging the servo. Signal lines (+ and -) from top to bottom. Color:Black & Blue Material:plastic Package Contents: 1 * RC Servo Tester Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.