Replacement Splinter Guard 495209 Compatible with Festool FS-SP 5000 Track Saw Guide Rail

Compatibility: 495209 compatible with Festool splinter guard replacement strip replace 495207 compatible with Festool splinter guard replacement strip and is compatible with Festool FS/2, FS/2 KP, and FSK guide rails & Festool rail saws. Periodically replacing your splinter guard can keep your cuts splinterfree, especially if you are switching between , or using the guide rail with more than one saw.Function: You can replace the Splinter guard as needed to ensure alignment of the guide rail with the cutting line, and to prevent tearing during parallel and lateral cutting. The Splinter guard can match the saw blade, accurately align the cutting line, and save setup time. Clear Splinter guard enhance visibility of the cutting line.Compatible with Festool splinter guard replacement strip is made of rubber, and uses adhesive, with viscosity and parency. It can adhere to your guide rail without falling off easily.Replace instruction: As the splinter guard is cut into upon the first use, it reflects the exact cutting edge, meaning that it can be applied exactly at the scribe mark. You just need to remove the tape to use it. Prior fitting the splinter guard, you need to clean the rail with acetone and leave surface grease free.On a clean working surface, there is no risk of dust or debris getting on the tape.Pull off the adhesive strip or tape with the actual splinter guard to avoid sticking debris.Before installing the splinter guard, please use a shovel and acetone to remove remaining adhesive.When you re-apply the splinter guard, you can move it out a portion to allow for clean cutting.Material:plasticPackage Contents:1 x Track Saw Guide Rail