1.This amplifier can work in a wide frequency range with stable gain. When different gain values are needed, the supply voltage can be reduced or customized. With metal shell , which has a noise reduction effect 2.This amplifier's noise figure is 2dB (measured at 1.5GHz), owns smaller noise and larger dynamic range, especially suitable for RF receiving frontend circuits, and increase the communication distance 3.WIFI receiver RF front end and other places where low noise and small signal RF amplification is required! Due to its low performance, it can be perfectly matched with circuits. The product is very thin, very pratical. 4.The product has a wide frequency range, high gain, low noise figure. The lownoise amplifier module can provide very low noise in a wide frequency range. This can provide a communication effect between the receiver and the transmitter 5.Wide range of applications, used for shortwave, FM broadcasting, remote control receivers, cable TV signal amplifiers and other RF signal amplification that require low noise. Item Type:RF Wideband Low Noise Amplifier LNA Power Supply Voltage:12V DC (typical current value 75MA) Gain:19.5DB input and output impedance:50 ohms Maximum Output Power:19.5dBm (under 6VPP/50 ohm load) Input Signal: equal 0DBM (the output signal is already distorted when input is 0dBm) Bandwidth:1MHz to 3GHz (gain is different at different frequencies) Noise Figure:2dB (measured at 1.5GHz) With metal shell Others:When different gain values are needed, the power supply voltage can be reduced or customized. Point Frequency Gain: F=15.2MHZ GAIN=17.99DB F=345.2MHZ GAIN=19.55DB F=945.2MHZ GAIN=18.09DB F=1.500GHZ GAIN=16.16DB F=1.955GHZ GAIN=15.77DB F=2.295 GHZ GAIN=14.11DB F=2.610 GHZGAIN=13.60DB F=2.895MHZ GAIN=12.56DB Colour:As Shown Material:PC+Metal Package Contents: 1 * Amplifier Module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.