Xy-dt01 Digital Micro Temperature Controller -40-110°C with LCD Display Waterproof Sensor

Temperature controller: - Temperature range: -40-110 - Equipped with HD LCD display and 4 buttons - Relay type, additional power supply required for the load Specification: - 220V 30A high power relay - Suitable for equipment including refrigerator, brooder, incubator, fermenter, greenhouse, etc. - Operation: Connect power supply and heating/cooling equipment, place the probe and set the temperature for operation Function details: 1. Heating/Cooling Function - Heating Mode 'H': when the detected temperature ≤ set temperature - hysteresis temperature, the relay turns on and heating equipment starts working; when the detected temperature ≥ set temperature, the relay disconnects and heating equipment stops working - Cooling Mode 'C' follows the same working principle 2. Delay Start & Temperature Correction Function - Delay Start 'OPH': When a heating or cooling job is completed, the system starts timing 'T'. When T ≥ OPH, the system can perform the next round of heating or cooling work - Temperature Correction 'OFE' (-10.0-10.0): Used to correct temperature deviations during long-term operation. Actual temperature = measured temperature + calibration value 3. High Temperature Alarm Function - When the actual temperature ≥ alarm temperature, the system activates sound and light alarm and disconnects the relay; press any button to stop the sound and light alarm Use Steps: 1. Connect the sensor to the controller 2. Connect the controller to power supply 3. Adjust start temperature, stop temperature and temperature correction 4. Disconnect the power supply 5. Connect the load with its power supply to the relay output terminal if needed 6. Reconnect the controller to power supply 7. Test and run Material: plastic Package Contents: 1 x XY-DT01 Digital Temperature Controller